Post by vangelis on Nov 21, 2015 11:05:51 GMT 1
Hi,
Some of my synths I made in SE v1.1914 sometimes output a DC offset (0Hz) noize..
Is there a way of beating this in the development, excluding the addition of a hi pass filter at the end of the chain?
And if this is the only way, do you have in mind any good HPF with a decent slope as to leave my low end unfiltered but filter out anything below 20 Hz?
Thank you
Vangelis
Some of my synths I made in SE v1.1914 sometimes output a DC offset (0Hz) noize..
Is there a way of beating this in the development, excluding the addition of a hi pass filter at the end of the chain?
And if this is the only way, do you have in mind any good HPF with a decent slope as to leave my low end unfiltered but filter out anything below 20 Hz?
Thank you
Vangelis
